How Do You Separate Light Switches?

Ensure that each switch and the light it controls are connected using 12-gauge electrical cable. Each cable should have one end pulled through the rear of one of the electrical boxes for the light fixtures. Remove 1/2 inch of insulation from the ends of each cable by stripping both ends with a knife, separating the wires, then stripping the wires again.

How do I connect two light switches together?

Connect the hot wire from your power source to both switches. Connect the hot wire for the light/fan to one switch and the outdoor light to the other switch. Connect all of the neutral and ground wires together. You also said that you would like to have a fan control.

How do I add a 2-gang box to my light switch?

  1. Replace the switch with a new one.
  2. Removing your present box and replacing it with a 2-gang box will save you time and money.
  3. Connect the hot wire from your power source to both switches.
  4. Connect the hot wire for the light/fan to one switch and the outdoor light to the other switch.
  1. Connect all of the neutral and ground wires together.
  2. You also said that you would like to have a fan control.

How do you wire a red and black light switch?

(Ensure that the wire nuts are the right size.) Each of these pigtails should be connected to a switch at the bottom of the circuit. The red wire from the 14/3 should be connected to the opposite terminal of Switch 1 (see illustration). Take the black wire from the 14/3 and connect it to switch number two. The black wire is used to create the exterior light, which is connected to switch 3.

Leave a Reply

Your email address will not be published. Required fields are marked *